Ford Recall 05S28


Reference: Ford Recall 05S28
(Speed Control System Modification)

As a result of several engine compartment fires Ford recalled multiple (3.8 million) vehicles under NHTSA/Ford Recall number 05S28 to replace a wiring harness.  The retrofit was to be completed in November of 2005.  All owners/users of these vehicles were to go to their local Ford dealer to register for the recall and have the cruise control circuit wiring disconnected until replacement parts could be installed.

Since that time, the following letter has been issued by Ford Service Engineering Operations Director Frank M. Ligon:


In September 2005, you were mailed a letter announcing Safety Recall 05S28 (Speed Control System Modification). At that time, we anticipated that service parts would be available in November 2005.  However, the availability of service parts has been delayed until February 2006.  We urge you to contact your dealer in February to schedule an appointment to have the new parts installed.  Until these parts are available, you dealer is still authorized to perform a temporary repair, which includes disconecting the speed control system on your vehicle.

September 7,2005

DEARBORN, Mich., Sept. 7 – Ford Motor Company announced today that it is conducting a voluntary safety recall on 1994-2002 Ford F-150, Ford Expedition, Lincoln Navigator and Ford Bronco vehicles to correct a systems interaction that could cause the speed control deactivation switch to overheat and lead to an underhood fire. Ford estimates that there are approximately 3.8 million of these vehicles on the road today in the U.S.

The make and model years of affected vehicles include: 1994-2002 Ford F-150s, 1997-2002 Ford Expeditions, 1998-2002 Lincoln Navigators and 1994-1996 Ford Broncos equipped with factory-installed speed control.

Ford has worked closely with NHTSA to investigate this issue. Ford’s investigation found that brake fluid may leak through the speed control deactivation switch into the speed control system electrical components, potentially corroding them. In rare cases, the corrosion in the electrical components can lead to increasing resistance and higher electrical current flow through the system. Together, these conditions could lead to overheating and, possibly, a fire at the switch. This system interaction is the result of the close proximity and orientation of the speed control components in the recalled vehicles.

To address this issue, Ford will install a fused wiring harness between the speed control deactivation switch and the speed control mechanism of the affected vehicles. This will act as a circuit breaker, eliminating the electrical current to the switch in the rare event of increased current flow through the switch.

"Our customers can be confident that this action will prevent a speed control deactivation switch fire," said Ray Nevi, assistant director, Ford Automotive Safety Office. " Our investigation was complex because the root cause turned out to be a system interaction rather than a single component and we had very few confirmed incidents to analyze. Despite this complexity, our solution effectively addresses the cause."

Ford is in the process of acquiring sufficient fused wiring harnesses to repair customers’ vehicles. Until replacement parts are available, customers are instructed to take their vehicles to a Ford or Lincoln Mercury dealership to have the speed control deactivated.

Owners of affected vehicles will be notified by mail immediately. Owners who have not already had their previously recalled 2000 model-year vehicles repaired should contact their dealers to make arrangements for the repair.

Customers may get further information at or they may contact Ford’s Customer Relationship Center at 1 – 888-222-2751. For a videotape message about the recall, customers may visit under the "Vehicle and Services" heading and then either the "Safety" tab or the "Owners" tab.

4 replies
  1. richard mccoy
    richard mccoy says:

    Just recieved a notice of a recall 05s28 on a 1996 motorhome that we purchased just a while ago. The motorhome is in winter storage for the winter months and can not be moved till spring. Since the recall was not taken care of prior to my purchase how much time do I have to complete the service.
    Also I would like to have a close service place within 10-15 miles of Ossian,In 46777. Any suggestions. After all the motorhome only gets 4.8 MPGallon We have several truck repair shops in the area that work on our fire trucks. Would it be possible to use one for the shops under the waranty guidelines.

  2. William Botts
    William Botts says:

    I received the same letter from Ford on a 2000 Holiday Rambler I purchased. Mine too is storage. I plan on calling the Ford dealer next week and see what is up.

  3. Juan
    Juan says:

    I have an 02 Expedition. I bought it used last year (2019) and the dealer was happy to take care of it , 15 after the recall was announced. Just make sure to make an appointment so they have the harness in stock.


Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *